2.
GENERAL OVERVIEW
2.1 Recommendations and Helpful
5
Hints
• This manual is available online only, so keep a short cut link to it on your smart devise or
simply scan the QR code on the front sticker.
• Read the manual to optimize and safely operate your chlorinator.
• To stop the sun from removing chlorine, it is recommended to use stabiliser in the swimming
pool.
• Maintain your salt levels between 3500-4000ppm and 1200ppm - 1800ppm for XR25LS and
XR35LS Freshwater/Ultra-Low Salt models, for optimum performance.
• Decrease the output when the water temperature goes down (less than 15
°C) to extend cell
life as high chlorine levels are not needed in winter.
• Increase chlorine production when temperature goes up again.
2.2
Contents
2.3 Tools Needed
Wall Mounting
Bracket with Level
Power Pack
2 x 50/40
Reducing Bushes
Cell & Cell Housing
With Unions
Installation &
Warranty Card
2 x Green Wall
Plugs with Screws
Drill with 6mm bit
Basic PVC Fittings
Hacksaw
Screwdriver
PVC Glue &
Primer