9
4. How to Set Auto Power Off
Auto-Power off makes the battery's life longer.
When you don't operate the scale, this function makes the power OFF
automatically.
Before setting the Auto Power Off, make sure that the power is OFF.
While you press the ZERO
key, press the ON/OFF key,
then you will see the AP-10.
(If you have set this before,
display will show previous
value.)
Press the TARE key, until
the display shows the "AP-x0"
that you wish to take.
(Refer to TABLE 1.)
Press the ZERO key, then
the scale saves what you
programmed and shows all the
segments and count up "0" to "9".
DISPLAY FUNCTION
AP-00 This function will keep scale on continuously.
AP-10 If you don't operate the scale for 10 minutes, this function will turn the power OFF.
AP-20 If you don't operate the scale for 20 minutes, this function will turn the power OFF.
AP-30 If you don't operate the scale for 30 minutes, this function will turn the power OFF.
TABLE 1.
BATTERY SYSTEM
LOW BATTERY
When the battery is low, display will show the "BAT" indication.
A new battery is required. Battery compartment is located on the bottom of the
scale.
If you use the scale without replacing the battery, display will show "LObAt" and
then scale will shut OFF.
To Next Page
Loading...
Need help?
General
