6 | support@casabrews.com
01. Rinse the water tank. Remove the water tank lid and fill the water tank with cold water up to the MAX level
of the tank.
02. Insert the plug into a wall outlet with suitable voltage(120V, 60Hz).
03. Press the Power button, the Power indicator light turns on and the coee machine starts to preheat
automatically. Once the preheating is finished, the TEMP Ready indicator will light up continuously. This
preheating process takes about 2 minutes.
04. Place a empty cup under the Steam Wand. Turn on the Steam Knob, then press the Espresso button. Let the
hot water flow out of the Steam Wand about 80 ml, then press the Espresso button again and turn o the
Steam Knob. This process is let the water flow into the empty pump for the first use.
05. Insert the Filter into the Filter Holder. (see image.1)
06. Insert the Filter Holder without coee grounds into the Brew Head with a 45°
movement to the left and turn it to the right to lock it in place. The Portafilter must be
perpendicular to the machine or slightly tilted towards the right. (see image.2)
07. Place a empty cup under the Filter Holder and press the Espresso button.
08. 8.After the cup has been filled with water, press the Espresso button again to stop and
pour the water out.
Now your coee machine is ready to use.
Before First Use
There will be a loud noise and little shake when the machine running first time. It’s normal for a
20 bar pump. The noise will be weak in the future using.
NOTE:
image.1
image.2
TEMP Ready
Coffee
Hot Water
Power
To Next Page
