How to connect hydraulic hoses to Cascade Power Tool attachment?
To connect hydraulic hoses to the Cascade Power Tool attachment, use Cascade Attachment Installation Kit No. 659245 for non-sideshifting attachments and attachments with solenoid adaption, Kit No. 659249 for sideshifting clamps OR use hoses and fittings as shown.
What to do if I need to connect hose to the valve CLAMP port of Cascade Power Tool?
If you need to connect a No. 6 hose to the valve CLAMP (CL) port on your Cascade Power Tool, use a 6-8 reducer.
General| Brand | Cascade |
|---|---|
| Model | 50D |
| Category | Power Tool |
| Language | English |
Specifies hydraulic pressure, flow volume, and carriage mount dimensions for truck compatibility.
Step-by-step guide for mounting the attachment onto the lift truck carriage.
Steps for securely mounting the attachment onto the truck's carriage bars.
Instructions for securing the attachment using quick-change or bolt-on lower hooks.
Checks and tests to perform before initial operation of the attachment.
Procedure to test hydraulic pressure in the clamp circuit to diagnose issues.
Method to test check valves by monitoring pressure drop in the clamp circuit.
Procedure to test individual cylinders by monitoring pressure drop after clamping.
Tests to diagnose sideshift circuit issues by measuring pressure changes for left and right shifts.
Troubleshooting steps for the electrical circuit of solenoid-equipped attachments.
Detailed steps for safely removing the attachment from the lift truck.
Procedures for removing and reinstalling the fork or arm assemblies from the attachment.
Procedures for removing and installing hydraulic cylinders from the clamp frame.
How to adjust restrictor cartridges for equal arm travel during opening and closing.
Steps to remove check valves from top mount valve assemblies.
Table of torque values for various fasteners in US and metric units for D-Series attachments.
To Next Page
