How to connect hydraulic hoses to Cascade Power Tool attachment?
To connect hydraulic hoses to the Cascade Power Tool attachment, use Cascade Attachment Installation Kit No. 659245 for non-sideshifting attachments and attachments with solenoid adaption, Kit No. 659249 for sideshifting clamps OR use hoses and fittings as shown.
What to do if I need to connect hose to the valve CLAMP port of Cascade Power Tool?
If you need to connect a No. 6 hose to the valve CLAMP (CL) port on your Cascade Power Tool, use a 6-8 reducer.
Provides installation, maintenance, troubleshooting, service, and specifications for D-Series clamps.
Explains WARNING, CAUTION, IMPORTANT, and NOTE statements used throughout the manual.
Details truck relief setting, flow volume, and carriage mount dimensions for compatibility.
Specifies hose and fitting requirements for non-sideshifting and sideshifting clamp hydraulic supply.
Step-by-step guide for attaching the overhead hoist, preparing hoses, mounting the attachment, and securing hooks.
Instructions for fabricating and installing custom arms on attachment bases.
Pre-operation checks including cylinder nuts, leaks, arm travel, and functional testing.
Maintenance tasks for every 100 hours: anchor joint, arm bearings, and capscrew torque.
Maintenance tasks for every 500 hours: hook clearance, lower/upper capscrews, and clamp force.
Inspect arm bearings for wear; replace if worn below 0.040 in. thickness.
Inspect arm bearings for wear and tighten frame mounting plate capscrews.
Covers truck system requirements, tools, and a general troubleshooting chart for common issues.
Hosing diagrams and circuit schematics for non-sideshifting units with top mount valves.
Hosing diagrams and circuit schematics for non-sideshifting units with center mount valves.
Lists potential problem areas for clamp function, including pressure tests and electrical checks.
Step-by-step guide to safely remove the attachment from the lift truck.
Procedures for arm assembly removal, installation, inspection, and service.
Procedures for hydraulic cylinder removal, installation, and service.
Procedures for cylinder disassembly, inspection, and reassembly.
Information on restrictor cartridges, including adjustment and service.
Procedures for removing and servicing check valves in top and center mount assemblies.
Procedures for disassembling and reassembling the base unit frame and mounting plate.
Procedures for solenoid valve coil service and general valve service.
Provides technical specifications for the D-Series clamps, including hydraulics and carriage.
General| Brand | Cascade |
|---|---|
| Model | 70D |
| Category | Power Tool |
| Language | English |
To Next Page
