Using Your Bagless Vacuum
Assembling your Vacuum Cleaner
1. Before use, please ensure the electrical voltage and frequency of the circuit
corresponds to those indicated on the appliance.
2. Pull the power cable from the vacuum cleaner and insert it into the power plug.
The ‘yellow’ marker on the power cable indicates the ideal cable length. The ‘red’
marker indicates the maximum power cable length.
WARNING: Do not extend the cable beyond the red marker.
3. Switch the power point on.
4. Press the “ON/OFF” button to turn the vacuum cleaner on. It is advisable to set the
‘Suction power slide” to minimum before switching the appliance on.
5. Adjust the “Suction power slide” to the desired level for vacuuming.
6. Use the different cleaning attachments to suit the surface to be cleaned.
1. Connect the hose connector to the front cover of the vacuum
cleaner by pushing it in until it clicks into place. To release the
hose connector, push the two buttons located on the top of
the connector and pull away from the vacuum.
2. Connect the extension pole to the hose connector by pushing
it into place. Use reasonable force to push it to ensure there is
a tight seal.
3. Connect the extension pole onto the cleaning accessory by
pushing it into the corresponding hole. Use reasonable force to
ensure a tight seal .
To Next Page
Loading...
Need help?
General
