Case 2010 - Page 21

SECTION 00 - GENERAL INFORMATION - CHAPTER 2
00-3
Head Size
6.0 m 7.6 m 9.2 m
(20′)(25′)(30′)
Knife speed 575 CPM 575 CPM 575 CPM.................................
(1150 spm) (left side) (left side)
(1150 spm) (1150 spm)
560 CPM 560 CPM
(right side) (right side)
(1160 spm) (1160 spm)
Cutter bar
Knife sections (bolted) overserrated.......................
Knife guards forged steel - heat treated................................
Knifestroke 76mm 76mm 76mm.................................
(3″)(3″)(3″)
Cross Auger
Standard speed 158 RPM 158 RPM 158 RPM.............................
Optional speed 139 RPM 139 RPM 139 RPM..............................
Outside diameter 660 mm 660 mm 660 mm............................
(26″)(26″)(26″)
Flighting pitch 610 mm 610 mm 610 mm...............................
(24″)(24″)(24″)
Flighting width 127 mm 127 mm 127 mm..............................
(5″)(5″)(5″)
Number of auger fingers (Full length) 28 30 32...........
Finger diameter 16 mm 16 mm 16 mm.............................
(0.626″) (0.626″) (0.626″)
Reach beyond center tube 173 mm 173 mm 173 mm....................
(6-13/16″) (6-13/16″) (6-13/16″)
Auger adjustments 4 directions 4 directions 4 directions...........................
Auger mounting free to free to free to.............................
float float float
vertically vertically vertically