SECTION 58 - ATTACHMENT/HEADERS - CHAPTER 3
58-10
WOBBLE BOX ASSEMBLY
1. Install new yoke bushings, 1, if required.
10007641
1
23
2. Install new tapered roller bearing races, 1, if
required. Orient the races with the tapered faces
pointing outward from the center of the housing.
10007642
1
24
NOTE: If the eccentric shaft needle bearings require
replacement, the races must also be replaced.
3. Press a new needle bearing, 1, into the side
cover if it was previously removed. Rotate the
cover so the outside is facing up. Tap in a new oil
seal, 2.
4. Press a new needle bearing into the wobble box
casing if it was previously removed.
10007643
2
1
25
To Next Page
Loading...
