DANGER: Keep all machine parts away from live electrical lines. If work
must be done close to high voltage lines, have the utility company dis-
h. connect them. It is not necessary to actually contact a power line for the
.. electricity to ground through the machine. If power does ground through
the machine, remain on the machine and DO NOT TOUCH THE MACHINE
STRUCTURE. Refer to the following chart.
4-4-A
Conductor
Minimum Minimum
Voltage
Working
Clearance
Transit Clearance
from Conductor
from Conductor
50,000 volts or less
10' (3 m)
4' (1.2 m)
Over 50,000 volts
10' (3 m) plus 10' (3 m)
0.4" (10.2 mm)
for each 1,000 volts
over 50,000
345,000-750,000 volts
16' (4.8 m)
NOTE: IF ABOVE REQUIREMENTS ARE LESS STRINGENT THAN STATE
REQUIREMENTS, THE STATE REQUIREMENTS SHALL APPLY.
750997
751121
A
CAUTION: When raising a load above transport height, always level
the attachment with the bucket control as the load is raised. This will
prevent spillage of the load.
10-3
I').. WARNING: Check that the parking brake is set and the transmission
.. controls are in neutral before starting the engine.
4-1
/1);. CAUTION: Check that all lights (if so equipped) are functioning properly
.. before operating at night.
25-7
11
To Next Page
Loading...
