2000-15
84581916A Issued 3-12 Printed in E.C.
STEP 51
Tighten engine mounting bolts to a torque of 244 to
298 Nm (180 to 220 lb-ft).
STEP 52
Disconnect lifting equipment from engine lifting
brackets.
STEP 53
Connect engine oil drain hose to frame bracket.
STEP 54
BD03A172
At front of engine, position drive shaft on engine
coupling. Install six bolts to secure drive shaft to
engine coupling. Apply Loctite 242 to threads and
tighten the six bolts to a torque of 53 to 62 Nm (39 to
46 lb-ft).
STEP 55
BD07N589-01
Install the lower cover for the drive shaft.
STEP 56
BD07N588-01
Connect and turn on vacuum pump to the hydraulic
reservoir. Remove caps from fittings and plugs from
hoses. Connect hoses to brake pump following tags
installed during removal. Remove and discard tags.
Turn off and disconnect vacuum pump from hydraulic
reservoir.
STEP 57
BD07N598-01
Remove cap from fitting and plug from the hose,
connect fuel line (2). Connect fuel filter heater wires
(1). Remove and discard tag.
STEP 58
BD07N591-01
Remove cap from fitting and plug from the hose,
connect fuel line to EDC 7.
1
2
To Next Page
Loading...
