Case 521F - Page 50

2000-17
84581916A Issued 3-12 Printed in E.C.
STEP 63
BD07N581-01
BS08A030
Install the wires (2) to the starter solenoid, install the
ground cable and ground strap (3), to the starter.
Torque starter mounting nuts (1) to 40 to 50 Nm (29
to 37 pound-feet). Remove and discard tags.
NOTE: If the starter mounting studs (4) have to be
replaced apply Loctite 747 primer to studs and holes
and apply Loctite 271 to each stud and hole and
torque to 19 to 29 Nm (14 to 21 pound-feet).
STEP 64
BD07N582-01
Install bolt securing wiring harness (1) clamp to the
engine. Install ground wires (2) to the engine.
STEP 65
BD07N575-01
Connect the wiring to the alternator. Remove and
discard tags.
STEP 66
BD07N579-01
W110R395
If loader is equipped with air conditioning, mount the
compressor using the two mounting bolts (2),
connect the engine wiring harness connectors to air
compressor clutch connector (1). Remove and
discard tags.
2
1
3
1
4
1
2
2