1001-7
NOTE: Apply sealant/lubricant
to
male pipe threads.
The
first two threads should be left uncovered
to
avoid
system contamination. Screw pipe fitting into female pipe port
to
the finger tight position. Wrench tighten fitting
to
the appropriate turns from finger tight (TFFT) shown in table above, making sure the tube end
of
an elbow
or
tee
fitting
is
aligned
to
receive incoming tube
or
hose fitting.
Bur 7-52931 Issued 9-98 Printed
in
U.S.A.
To Next Page
Loading...
