2000-10
87. Install each lower side panel. Install the carriage
bolts, flat washers, lock washers, and nuts that
fasten the lower side panels. Tighten the nuts.
88. Install the hood. Disconnect the lifting equipment
from the hood.
89. Install the cap screws, lock washers, and flat
washers that fasten the hood. Tighten the cap
screws. Install the plugs in the hood.
Bur 7-12150
90. Install the precleaner. If the air cleaner is
equipped with a cap, install the cap and tighten
the clamp.
91. Close the grille.
92. Close the access door on each side of the
engine compartment.
93. Remove the floor jack from under the
transmission.
Issued 1-99 Printed in U.S.A.
To Next Page
Loading...
