Case 821B - Page 32

2001-14
STEP
61
Remove the large counterweight from the machine.
STEP 62
Repeat steps
56
through
61
for the other counter-
weight(s).
STEP 63
If
the machine
is
equipped with ether injection, discon-
nect the tube from
the
valve.
STEP 64
If
the machine
is
equipped with ether injection, discon-
nect the wire harness from the connector.
Rae
7-60130
STEP 65
If
the
machine
is
equipped with ether injection, cut
the
tie
strap that fastens
the
wire harness
to
the
bracket.
STEP 66
If
the machine
is
equipped with a backup alarm, dis-
connect
the
wires from
the
backup alarm and pull
the
wires through
the
grommet.
STEP 67
Cut the
tie
strap that fastens the connectors to the wire
harness for the lamps at the right side of the radiator
shroud. Disconnect both connectors.
Issued
7-93
Printed
in
U.S.A.