2001-20
STEP 100
If the machine
is
equipped with a heater, disconnect the
hose from the top fitting. Install a plug
in
the hose.
STEP
101
Disconnect the cables from the battery terminal of the
starter solenoid.
NOTE: Fasten identification tags
to
the cables for the
starter solenoid.
STEP 102
Disconnect the cables from the switch terminal of the
starter solenoid.
Rae
7-60130
STEP 103
Disconnect the wire from the temperature sender.
STEP 104
If
the machine
is
equipped with a heater, loosen and
remove
the
cap screw and lock washer that fasten
the
clamp for the hoses to
the
left side of the flywheel
housing.
STEP 105
Loosen and remove
the
brass nut and brass flat
washers that fasten the wires to the stud
in
the left side
of the flywheel housing. Remove the wires.
Issued
7-93
Printed
in
US
A
To Next Page
Loading...
