NOTE:
If
the machine
is
equipped with an air condi-
tioner, do Steps 106 through
115.
If
the
machine
is
not
equipped with an air conditioner, go
to
Step
116.
STEP 106
Disconnect the connectors for the compressor
STEP 107
Cut
the
tie straps that fasten the wire harness to the
compressor hose.
STEP 108
If
the machine
is
equipped with ether injection, discon-
nect the connector for the temperature switch.
Rae
7-60130
2001-21
STEP 109
If
the machine
is
equipped with ether injection, discon-
nect the tube fitting from
the
intake manifold.
STEP 110
►
Loosen and remove the nuts, lock washers, and bolts
that fasten the clamps for the compressor hoses and
the wire harness to the bracket
on
the engine.
STEP
111
Loosen and remove the cap screw, lock washer, and
flat washer that fasten the adjusting strap for the com-
pressor.
Issued
7-93
Printed
in
U.S.A.
To Next Page
Loading...
