STEP 162
Install the U-bolt, flat washers, and self-locking nuts
that fasten the fuel filler neck to
the
frame. Tighten the
self-locking nuts.
NOTE: If
the
machine is equipped with
an
air condi-
tioner, do Steps
163
through
169.
If
the
machine is not
equipped with an air conditioner,
go
to
Step
170.
STEP 163
Remove
the
wire that
was
used
to
tie the compressor
out of
the
way and install the compressor
on
the
bracket. Align the compressor with the bracket and
install
the
bolt and flat washers.
STEP 164
··-:::···
Install the flat washer, lock washer, and nut on the bolt
and tighten the
nut.
Rae
7-60130
2001-31
STEP 165
Install the belt
on
the pulley for the compressor.
STEP 166
Install the cap screw, lock washer, and flat washer that
fasten the adjusting strap for the compressor.
Do
not
tighten the cap screw
all
the way at this time.
STEP 167
Use a prybar to move the compressor away from the
engine. Tighten the cap screw.
Issued
7-93
Printed
in
U.S.A.
To Next Page
Loading...
