Case 836C - Page 27

INTRODUCTION
3.4–boltangeconnectionsconformingtoISO6162-1andSAEJ518-1(Code61)andto
ISO6162-2andSAEJ518-2(Code62):
NOTE:
TorquevaluesaccordingISO6162:
–Itisimportantthatallscrewsbelightlytorquedbeforeapplyingthenalrecommendedtorquevaluestoavoidbreak-
ingthesplitangeclampsorone-pieceangeclampsduringinstallation.
–Calculatedwithacoefcientoffrictionat0.17.
SS14G1533
PositionDesignation
1
Shapeoptional
2
O-ring
3Flangeclamp
4Flangedhead
5
Screw
6Hardenedwasher
7
Faceofportonadapter,
pump,etc.
Assembly:
A.Makesuresealingsurfacesarefreeofburrs,nicks,scratchesoranycontamination.
B.LubricatetheO-ringlightlywithsystemuidorcompatiblelubricant.
C.Positionangeandclamphalves.
D.Placelockwashersonboltsandboltthroughclamphalves.
E.Fingertightenallfourboltsmakingcertaintheangeandttingshoulderarestartedsquarely.ALLBOLTSMUST
BEEVENLYTORQUED.Donottightenanyoneboltfullybeforegoingontothenextone.Partiallytighteneach
boltasshownbelowandrepeatthissequenceuntilallboltsaretightenedtothespeciedtorqueforthatboltsize.
SS14G1504
4782904822/01/2015
20