Case 836C - Page 37

INTRODUCTION
Reassemblinghydraulicequipment
•
Cleanpartsinawellventilatedroom.
•
Removeresidualoilwithcompressedair,andapplyfreshhydraulicoilorgearoiltosurfacesbeforereassembly.
•
Replaceremovedo-rings,back-upringsandoilsealswithnewones.Applygearoilonthembeforereassembling.
•
Thoroughlycleananddrysurfacesonwhichliquidsealantmustbereapplied.
•
Beforeassembling,removerustpreventivesonnewparts.
•
Usespecialtoolstotbearings,bushingandoilseal.
•
Assemblepartsmatchingtothemarks.
•
Aftercompletion,checkthatthereisnoomissionofparts.
4782904822/01/2015
30