Power Saving
Auto adjust
Illumination duration
Operation tone enable/disable
Day of the week language
Date display format
12/24-hour timekeeping
Day
Month
Ye a r
Minutes
Hours
Seconds
Summer time
Home City
3.
Configure the date and time settings.
●
To reset the seconds to 00: Press (D).
1 is added to the minutes when the
current count is between 30 and 59
seconds.
●
Use (D) and (B) to change the other
settings.
4.
Repeat steps 2 and 3 to configure the
other settings.
5.
Press (A) to exit the setting screen.
Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto signal
receive
or connection with a phone may cause
problems, you can perform the procedure
below to disable it. To re-enable auto time
adjustment, perform the same operation
again.
1.
Hold
down (A) for about two seconds until
[HT] flashes.
2.
Press (C) 13 times.
This displays [RECEIVING].
3.
Press (D) to select the auto time
adjustment setting you want.
[OFF]: Auto time adjustment disabled.
[On]: Enable auto time adjustment.
4.
Press (A) to exit the setting screen.
Using Mobile Link with
a Mobile Phone
While there is a Bluetooth connection
between
the watch and phone, the watch time
setting is adjusted automatically. You can also
change the watch’s other settings.
Note
●
This
function is available only while G-
SHOCK Connected is running on the
phone.
●
This section describes watch and
phone operations.
X
: Watch operation
Y
: Phone operation
Getting Ready
A
Install the required app on your
phone.
In Google Play or the App Store, search for the
CASIO “G-SHOCK Connected” app and
install it on your phone.
B
Configure Bluetooth settings.
Enable the phone’s Bluetooth.
Note
●
For details about setting procedures,
see your phone documentation.
C
Pair the watch with a phone.
Before you can use the watch in combination
with a phone, you first need to pair them.
1.
Move
the phone to be paired with close to
(within one meter of) the watch.
2.
Y
On the Home Screen, tap the “G-
SHOCK Connected
” icon.
3.
Y
Perform the operation shown on the
phone screen to be paired with.
●
If a pairing prompt message appears,
perform the operation shown on the
phone screen.
●
If pairing fails for some reason,
[NG] or
[ERR] will appear on the display
momentarily and then the timekeeping
screen will appear. Perform the pairing
procedure again from the beginning.
Pairing complete.Pairing started.
Note
●
The first time you start up G-SHOCK
Connected, a message will appear on
your phone asking if you want to
enable location information
acquisition.
Configure settings to allow
background use of location
information.
Operation Guide 3459/3461
7
To Next Page
Loading...
Need help?
General
