EasyManuals Logo

Casio 5537 User Manual

Casio 5537
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Viewing Measured Data
Records
You can use the procedure below to view lap
time records.
1.
Enter the Recall Mode.
l
Navigating Between Modes
2.
Use (E) to cycle through lap numbers.
Each press of (E) advances
sequentially through the lap numbers
from [L01] to [200].
E
E
E
E
Lap number
3.
Press (A) to display the lap time of the
currently displayed lap number.
Note
Lap time records in watch memory are
lap time measurements taken during a
single stopwatch elapsed time
measurement session (start of time
measurement from all zeros, up to the
point stopwatch time is reset to all
zeros). Records are assigned
numbers in the sequence the lap time
measurements are performed.
Lap Times
A lap time shows the time elapsed during a
specific lap. The stopwatch normally shows
the ongoing elapsed time measurement from
the beginning of the race. The current lap time
is kept internally by the watch, and is not
displayed until you press (E). The difference
between the current lap time and the target
time is also indicated.
E
Start
E
Lap 1
E
A
Goal
Lap 2
Lap 3
Note
Lap times can be viewed with EDIFICE
Connected after measurement is
complete.
l
Viewing Stopwatch Data
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted in the cases described
below.
When battery power is low
Getting Ready
Enter the Timer Mode.
l
Navigating Between Modes
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
1.
Hold down (A) for at least two seconds.
Release the button when the hour digits
start to flash.
This causes the hours digit to flash.
Hours
2.
Use (B) and (E) to change the timer hours
setting.
3.
Press (D).
This causes the minutes digits to flash.
Minutes
4.
Use (B) and (E) to change the timer
minutes setting.
5.
Press (D).
This causes the seconds digits to flash.
Seconds
6.
Use (B) and (E) to change the timer
seconds setting.
7.
Press (A) to exit the setting screen.
Operation Guide 5537
12

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Casio 5537 and is the answer not in the manual?

Casio 5537 Specifications

General IconGeneral
BrandCasio
Model5537
CategoryWatch
LanguageEnglish

Related product manuals