Casio 5582 User Manual

●
Swapping Your World Time and Home
Time
1.
Y
Tap the “CASIO WATCHES” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CNCT] starts to flash.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing and the second hand will
move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to swap your Home Time
with your World Time.
Note
●
Auto time adjustment does not work for
24 hours after swapping of the Home
Time and World Time.
Adjusting Hand Alignment
If the hands are out of alignment even though
auto time adjustment is being performed, use
CASIO WATCHES to adjust them.
1.
Y
Tap the “CASIO WATCHES” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CNCT] starts to flash.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing and the second hand will
move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to correct hand alignment.
Phone Finder
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
●
Do not use this function in areas where
phone call tones are restricted.
●
The tone sounds at a high volume. Do
not use this function when listening to
phone output over earphones.
1.
X
If the watch is connected with a phone,
press any button to terminate the
connection.
Trying to connect
Disconnected
2.
X
If the watch is in any mode besides the
Timekeeping Mode, hold down (D) for at
least two seconds to enter the
Timekeeping Mode.
3.
X
Hold down (E) for at least 1.5 seconds
until the second hand moves to [R].
The phone will sound a tone when it
establishes a connection with the watch.
●
It will take a few seconds before the
phone tone sounds.
ConnectedSearching for phone
4.
X
Press any button to stop the tone.
●
You can press any watch button to stop
the phone tone only during the first 30
seconds after it starts to sound.
Configuring Watch Settings
You can use CASIO WATCHES to specify the
amount of time until a Bluetooth connection is
automatically terminated, to enable or disable
the watch operation tone, and to configure
other settings.
1.
Y
Tap the “CASIO WATCHES” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CNCT] starts to flash.
When a connection is established
between the watch and phone, [CNCT]
will stop flashing and the second hand will
move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Select the setting you want to change
and then perform the operation shown on
the phone screen.
Operation Guide 5582
7

Casio 5582 Specifications

General

Brand	Casio
Model	5582
Category	Watch
Language	English