Using Watch Operations to
Adjust the Time Setting
If your watch cannot connect with a phone for
some reason, you can use watch operations
to adjust date and time settings.
●
Setting a Home City
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
enable or disable summer time.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
The currently selected Home City will
appear on the display.
3. Rotate the crown to display the city you
want to use.
●
For information about city codes, refer
to the information below.
l
City Table
4. Press (B).
5. Rotate the crown to select a summer time
setting.
Rotating the crown cycles through the
setting items shown below.
●
[AUTO]
The watch switches between standard
time and summer time automatically.
●
[OFF]
The watch always indicates standard
time.
●
[ON]
The watch always indicates summer
time.
6. Push the crown back in and then lock it.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
●
The [AUTO] summer time setting is
valid when the watch’s Home City is in
an area where a time signal can be
received.
●
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
The currently selected Home City will
appear on the display.
3. Press (D).
This causes the hours and minutes digits
to flash.
4. Rotate the crown to change the minute
setting.
●
The hour digit changes in sync with the
minute digit change.
Watch Operation Guide 5713
27
To Next Page
Loading...
Need help?
General
