Controlling the Sound of a Performance
EN-108
4.
Rotate the dial to select the reverb type.
The following shows the available reverb type settings.
• After you rotate the dial once to select a reverb type, you can change the selection further using
– and +.
• To return the setting to its initial default, press – and + at the same time.
• To go back to the previous screen, press BACK.
5.
To exit the setting operation, press EXIT.
• You can also use the knobs to adjust how reverb is applied to a tone. For more information, see
“Using the Knobs to Change the Sound” (page EN-91).
Setting Display Name
Off Off
Reverb Recommended for Each Tone Tone
Room 1 to 5 Room 1 to 5
Large Room 1 or 2 Large Room 1 or 2
Hall 1 to 6 Hall 1 to 6
Stadium 1 to 3 Stadium 1 to 3
Plate 1 or 2 Plate 1 or 2
Delay Delay
Pan Delay Pan Delay
Long Delay 1, 2 Long Delay 1, 2
Church Church
Cathedral Cathedral
To Next Page
Loading...
