Controlling the Sound of a Performance
EN-111
5.
Rotate the dial to select the chorus type.
Available chorus type settings are shown in the table below.
• After you rotate the dial once to select a chorus type, you can change the selection further using
– and +.
• To return the setting to its initial default, press – and + at the same time.
• To go back to the previous screen, press BACK.
• To return to the Reverb screen, press REVERB.
6.
To exit the setting operation, press EXIT.
• Selecting a chorus type other than Tone increases the Chorus Send of the keyboard part.
• You can also use the knobs to adjust how chorus is applied to a tone. For more information, see
“Using the Knobs to Change the Sound” (page EN-91).
Setting Display Name
Chorus setting recommended for each tone Tone
Chorus 1 to 4 Chorus 1 to 4
Feedback Chorus Feedback Chorus
Deep Chorus Deep Chorus
Flanger 1 to 4 Flanger 1 to 4
Short Delay 1, 2 Short Delay 1, 2
To Next Page
Loading...
