Playing with a Rhythm Backing
EN-167
■ Intro
1.
While rhythm play is stopped, press INTRO.
This displays “I” and plays the intro.
• Pressing VAR1 while an intro is playing displays “I >V1”. Pressing VAR2 displays “I >V2”.
• If “I” is left on the display without changing it, “V1” starts to play following the introduction.
• After you press VAR1 (“I >V1” displayed) or VAR2 (“I >V2” displayed), pressing the same button
(VAR1 or VAR2) again interrupts the intro play up to the current measure and then plays the
current rhythm pattern (V1 or V2).
• If you press INTRO while a rhythm is playing, the rhythm changes to the intro from the beginning
of the next measure, and “I” appears on the display.
■ Ending
1.
While a rhythm is playing, press ENDING.
When rhythm play enters the next measure, “
E
” appears on the display to indicate that an ending is
being played. After the ending, rhythm play stops.
• Pressing VAR1 while an ending is playing switches to “V1” from the next measure. Pressing
VAR2 switches to “V2”.
■ Synchro Start
While in Synchro Start standby, you can preset the pattern that plays when rhythm play starts by
pressing INTRO (“I” flashes), VAR1 (“V1” flashes), or VAR2 (“V2” flashes).
To Next Page
Loading...
