Controlling the Sound of a Performance
EN-80
5.
Press UPPER1.
“U1” disappears from the display, indicating that the pedal effect is no longer applied to the
UPPER 1 part.
6.
To apply the pedal effect to the UPPER1 part, press UPPER1 again.
• In the same way, you can stop the pedal effect from being applied to the note by pressing
UPPER2 and to the LOWER part by pressing LOWER. Pressing UPPER2 causes “U2” to
disappear from the display, while pressing LOWER causes “L” to disappear.
7.
Press BACK to return to the pedal screen.
8.
To exit the setting operation, press EXIT.
• For information about parts, see “Layering and Splitting Tones” (page EN-123).
• Pedal part settings do not affect any of the following settings: start/stop, fill-in, arpeggiator hold,
master volume, tempo.
• When layer and split are enabled, the pedal effect is applied to the corresponding UPPER2 part and
to the LOWER part in accordance with how much the pedal is depressed.
To Next Page
Loading...
