Controlling the Sound of a Performance
EN-82
■ Adjusting the Note Sustain Time
Use the procedure below to change the sustain time when sustain is enabled.
1.
Press INSTRUMENT.
This displays the instrument tone screen.
2.
Long-press SUS.
This displays the sustain screen, which shows setting items for the UPPER1 part sustain time.
3.
If required, press UPPER1, UPPER2, and LOWER to select the part whose setting
you want to configure.
4.
Rotate the dial to change the setting.
• You can set a sustain time within the range of 0 to 9.
• After you rotate the dial once to select a value, you can change the value further using – and +.
• To return the setting to its initial default, press – and + at the same time.
• To go back to the previous screen, press BACK.
• Setting a value of “0” causes the indicator for the applicable part (“U1”, “U2”, “L”) to disappear
from the display.
B
To Next Page
Loading...
