Using the MIDI Recorder to Record
EN-104
5.
When you are editing the system track, you
can specify the event input target part.
• See “Selecting a System Track Part” (page EN-105).
• This step is not necessary when you are editing a solo
track. Proceed to step 6.
6.
If necessary, specify the velocity (keyboard
touch) and gate time rate (actual length) of the
note event you are about to input.
• The velocity and gate time rate settings you specify
here are applied to all of the note events you input until
you change them.
• Velocity can be specified as a value (1 to 127) or by
actually pressing a key (which sets a velocity in
accordance with your key pressure). The initial default
is 100.
• The gate time rate specifies the note length as a
percentage (1 to 100%) of the note value you specify
in step 7. For example, when the gate time rate is 80%
(initial default), a quarter note (96 ticks) becomes 76
ticks (96×0.8=76.8, decimal part cut off).
* When “Key On” is selected, the velocity of the keyboard
press when inputting the note event is reflected in the
velocity value.
7.
Specify the note value (event length) of the
event you are about to input in step 8.
*1 If you want to input a dotted note or triplet note, first press
a key from [1] to [6], and then press [7] or [8]. To input a
dotted quarter note, for example, press [3] and then [7].
• The note value specified in accordance with the key
input will appear on the right side of the display.
8.
Specify the event to be input.
*2 Extends the length of the previously input note event. For
example, if you input a quarter note event and wish to
extend it by an eighth note, perform the following button
operation: bm number key [4] (eighth note) -
cs REGISTRATION [3] (Tie).
• Inputting an event advances the input point by the note
value amount you specified in step 7.
9.
Repeat steps 5 through 8 as required.
• The operation in step 5 is not necessary as long as the
target part remains the same.
10.
To exit the Step Input Mode, press
cs REGISTRATION [1].
This causes the [STEP] indicator to disappear.
To specify this: Perform this operation:
Velocity (1) Press cs REGISTRATION [4].
(2) Use bn [–] and [+], or the bl dial to
specify a value or select “Key
On”.*
(3) Press the [4] (EXIT) bm number
key.
Gate Time Rate (1) Press cs REGISTRATION [5].
(2) Use bn [–] and [+] or the bl dial to
specify a percent value.
(3) Press the [4] (EXIT) bm number
key.
To input this note value: Press this bm number key:
Whole [1]
Half [2]
Quarter [3]
Eighth [4]
Sixteenth [5]
Thirty-second [6]
Dotted note*
1
[7]
Triplet*
1
[8]
To input this: Perform this operation:
Note event After specifying a note value in step 7,
press the keyboard key for the note
you want to input. Pressing multiple
keyboard keys at the same time inputs
a chord.
Rest After specifying a note value in step 7,
press cs REGISTRATION [2].
Tie*
2
After specifying a note value of a note
to tie with the previous note event in
step 7, press cs REGISTRATION
[3].
CT-X9000_8000IN_EN.book 104 ページ ２０１８年４月１２日 木曜日 午後１時８分
To Next Page
Loading...
