Using Phrase Pads
EN-56
6.
Press a cq PHRASE PAD button ([P1] to [P4])
to specify the phrase number of the recording
destination.
• This causes the indicator of the pad you press (P1 to
P4) to flash on the display.
7.
To start recording, press ck PLAY/STOP or
play something on the keyboard.
Playing on the keyboard automatically starts recording.
This displays the [RECORD] indicator.
• The number of measures and beats are counted up in
the upper right corner of the display. When the final
beat of the length (number of measures)* specified for
the phrase being edited is reached, the count restarts
from 001:01.
* For information about the number of measure setting,
see “Configuring Phrase Recording Settings” below.
8.
Timing in accordance with the MEASURE and
BEAT values on the display, play something on
the keyboard when required.
• What you record will play back when the display
returns to the measure and beat where it was
recorded. You can overdub the recording as many
times as you like while listening to the playback.
• Playback while recording is in progress is sound
produced by the KEYBOARD part group’s Part 6
(Phrase Pad 1) to Part 9 (Phrase Pad 4). If you want to
the change the mixer settings for playback during
phrase recording, select the part of pad currently being
recorded as the target for the operation under “To
configure mixer settings” (page EN-62).
9.
When you are finished recording, press
8 RECORD/STOP.
This causes the [RECORD] indicator to disappear.
If you change phrase recording settings, those settings will be
in effect for the subsequent recording operation as well.
Change the recording settings as required when recording a
new phrase.
1.
Press bk FUNCTION.
2.
Use the [1] (V) and [3] (W) bm number keys
to display “Phr Pad”, and then press [6]
(ENTER).
This displays “Phr Set”.
3.
Press 8 RECORD/STOP.
This causes the [RECORD] indicator to flash.
4.
Long-press 8 RECORD/STOP until “Length”
is displayed.
• This enters the phrase recording setting mode.
5.
Use the [1] (V) and [3] (W) keys to select the
item whose setting you want to change.
• For information about setting items, see “Phrase
Recording Setting Items” (page EN-56).
6.
When all the settings are the way you want,
press 8 RECORD/STOP.
This causes the [RECORD] indicator to disappear.
Configuring Phrase Recording
Settings
To configure phrase recording settings
Phrase Recording Setting Items
Item Name
(Display)
Description Settings
Number of
measures
(Length)
Specifies the length (number of
measures) of the phrase to be
recorded.
1 to 16
Quantize
(Quantize)
Specify either recording of notes
in the timing they are played on
the keyboard or automatic
alignment of notes based on a
note value. Selecting a setting
other than “Off” displays a note
value (4: quarter note, d: dotted
note, t: triplets).
Off, 4, 8,
16, 32,
4d, 8d,
16d, 32d,
4t, 8t, 16t,
32t
Metronome
(Metronom)
Specifies whether or not the
metronome should sound during
recording.
On, Off
Pre-count
(Precount)
Specifies whether or not to
sound a pre-count when
recording.
On, Off
CT-X9000_8000IN_EN.book 56 ページ ２０１８年４月１２日 木曜日 午後１時８分
To Next Page
Loading...
