English
Controlling the Keyboard Sounds
E-13
Turning off power will cause any sampled sound data on the
keyboard to be deleted.
■ How sampled sounds are played
Pressing Middle C (C4) will play back the original sound. The
keys to the left and right of C4 play the sound at different
pitches.
1.
Press
3
a number of times until “SmplAuto”
appears on the display (page E-4).
2.
Press
bn
(10-key) [–] key to select the OFF
setting.
This enables manual sampling. When this setting is
selected, sampling will not start until you press
4
.
• When the above setting is “oFF”, sampling starts when
you release
4
, not when you press it. Sampling will not
start if you keep
4
depressed.
You can apply various effects to the sample sound stored at
tone number 401.
1.
Use
bn
(10-key) to select a tone number from
402 to 411.
Tone numbers 402 to 411 actually represent effects
assigned to tone number 401. Selecting a tone will play
the sampled sound in a loop, along with the applicable
effect, as described below.
Turning off power clears sampled data!
Starting a Sampling Operation Manually
C4
S m
p
l A u t o
Applying Effects to a Sampled Sound
Effect
Name
Description
402 Loop 1 Loops the sampled sound.
403 Loop 2
Loops the sample sound and raises the
pitch of the resonating sound when the
keyboard key is released.
404 Loop 3
Loops the sample sound and lowers the
pitch of the resonating sound when the
keyboard key is released.
405 Pitch 1
Changes the pitch from low to high, at an
increasing rate.
406 Pitch 2
Changes pitch from high to low, at a
decreasing rate.
407 Pitch 3
Changes pitch from high to low, at a
decreasing rate, and then raises the pitch
when the key is released.
408 Tremolo Alternates volume between high and low.
409 Funny 1
Adds vibrato and changes pitch by a
gradually increasing amount.
410 Funny 2
Alternates between high pitch and low
pitch.
411 Funny 3
Adds vibrato and changes pitch from low
to high.
To Next Page
Loading...
