Casio FC-100V User Manual

E-92
Example 3: To calculate the sales quantity (QTY) from
variable cost and unit variable cost
1. Input the required values from among 4, 5, and 6 in
the Setting Values table (page E-91).
•In this example, use
fc to select 4 “VC”,
input 15000, and then
press E.
•Use fc to select 5 “VCU”, input 30, and then press
E.
2. Select the value you want to calculate.
•In this example, use
fc to select 6 “QTY”.
3. Press l to perform the
calculation.
• The result of a 6 “QTY” (sales quantity) calculation is
also assigned to variable 3 “QTY”.
Example 4: To calculate the variable cost (VC) and unit
variable cost (VCU)
•Use the same procedure as Example 3, substituting the
required values.
A QTY CONV. Sub-mode Financial
Calculation Variables (VARS)
•Variables SAL, PRC, QTY, VC, and VCU are used in the
QTY CONV. sub-mode.
•QTY CONV. sub-mode variable contents are cleared
whenever you change to another mode other than the
BEVN Mode sub-modes (BEV, MOS, DOL, DFL, DCL,
QTY CONV.).

Casio FC-100V Specifications

General

Type	Financial
Cover	Yes
Form factor	Pocket
Control type	Buttons
Product color	Gray
Housing material	Plastic
Digits	10 digits
Display type	Dot-matrix
Display tilting	No
Display size (HxV)	31 x 96 mm
Display number of lines	4 lines
Display number of characters	15
Storage media type	Flash
Battery type	AAA
Power source	Battery
Battery life (max)	17000 h
Number of batteries supported	1
Operation	log, ln, 10x, ex, x2/ ^ / x√ , √, x-1, x!, nPr - nCr
Symbolic notation	Fraction, Square root
Conversion between	Decimal, Percent
Package type	Box
Package depth	245 mm
Package width	155 mm
Package height	43.1 mm
Package weight	368.7 g

Weight and Dimensions

Depth	161 mm
Width	80 mm
Height	13.7 mm
Weight	110 g