format. Outside the specified range, results are displayed using non-
exponential format.
Norm 1: 10
-2
> |x|, |x| ≧ 10
10
Norm 2: 10
-9
> |x|, |x| ≧ 10
10
Example: (LineIO) 1 ÷ 200 = 5 × 10
-3
(Norm 1)
0.005 (Norm 2)
Specifying the Fraction Display Format
To specify this
fraction display
format:
Perform this key operation:
Mixed (SETUP) (ab/c)
Improper (SETUP) (d/c)
Specifying the Stat Format
Specifies whether or not to display a FREQ (frequency) column in the
STAT Mode Statistics Editor.
To specify this: Perform this key operation:
Show FREQ Column (SETUP) (STAT) (ON)
Hide FREQ Column (SETUP) (STAT) (OFF)
Specifying the Table Format
Specifies whether to use function f(x) only or the two functions f(x) and g(x)
in the TABLE Mode.
To specify this: Perform this key operation:
f(x) only (SETUP) (TABLE) (f(x))
f(x) and g(x) (SETUP) (TABLE) (f(x),g(x))
Specifying the Recurring Decimal Format
Specifies whether or not to display calculation results using recurring
decimal form.
13
To Next Page
Loading...
