To specify this: Perform this key operation:
Use recurring decimal
form
(SETUP) (Rdec) (ON)
Do not use recurring
decimal form
(SETUP) (Rdec) (OFF)
Specifying the Decimal Point Display Format
Specifies whether to display a dot or a comma for the calculation result
decimal point. A dot is always displayed during input.
To specify this
decimal point
display format:
Perform this key operation:
Dot (.) (SETUP) (Disp) (Dot)
Comma (,) (SETUP) (Disp) (Comma)
Note
• When dot is selected as the decimal point, the separator for multiple results is a
comma (,). When comma is selected, the separator is a semicolon (;).
Adjusting Display Contrast
(SETUP) ( CONT )
See "Getting Started" for details.
Initializing Calculator Settings
Perform the following procedure to initialize the calculator, which returns
the calculation mode to COMP and returns all other settings, including
setup menu settings, to their initial defaults.
(CLR) (Setup) (Yes)
This setting: Is initialized to this:
Calculation Mode COMP
Display Format MthIO-MathO
Angle Unit Deg
14
To Next Page
Loading...
Need help?
General
