Casio fx-83GT PLUS - Page 7

mmm reer rrr certererrer erecrererer eres terrerT Teen
(3)Deg
)Rad
()Gra_
Specifies
degrees,
radians
or
grads
as
the
angle
unit for value input and calculation result display.
Note:
In
this
manual,
the
EEEJ
symbol
next
to
a
sample
operation
indicates
degrees,
while
the
[ZEJ
symbol
indicates
radians.
reenact uesengenetteseseneeicneenesemnseiznancinscieceensecissenmmennitensameneno>
(6)Fix [Sci ()Norm Specifies the number of digits for display of a
calculation result.
Fix: The value you specify (from 0 to 9) controls the number of decimal
places for displayed calculation results. Calculation results are rounded off
to the specified digit before being displayed.
Example: 100 + 7=14.286 (Fix 3)
14.29 (Fix 2)
Sci: The value you specify (from 1 to 10) controls the number of significant
digits for displayed calculation results. Calculation results are rounded off to
the specified digit before being displayed.
Example: 1+7= 1.4286 x 10° (Sci 5)
1.429x10" (Sci 4)
Norm: Selecting one of the two available settings (Norm 1, Norm 2)
determines the range in which results will be displayed in non-exponential
format.
Outside
the
specified
range,
results
are
displayed
using
exponential
format.
Norm
1:
10%
>
Lal,
kxl
2
10
=
Norm
2:
10°
>
Lal,
lx]
=
10°°
Example: 1+200=5x 10° (Norm 1)
0.005 (Norm 2)
@ Gable @@) die Specifies either mixed fraction (ab/c) or improper
fraction (d/c) for display of fractions in calculation results.
@
(3)STAT
GJON;
GOFF
Specifies
whether
or
not
to
display
a
FREQ
(frequency)
column
in the
STAT
Mode
Stat
Editor.
@
(4)Rdec
JON;
@)OFF
Specifies
whether
or
not
to
display
calculation
results
using
recurring
decimal
form.
@
@)Disp
G)Dot
;
(2)Comma_
Specifies
whether
to
display
a
dot
or
a
comma
for
the
calculation
result
decimal
point.
A
dot
is
always
displayed
during
input.
Note:
When
dot
is
selected
as
the
decimal
point,
the
separator
for
multiple
results
is
a
comma
(,).
When
comma
is
selected,
the
separator
is
a
semicolon
(;).
@
(6)
«CONT
Adjusts
display
contrast.
See
“Adjusting
Display
Contrast”
for
details.
Initializing Calculator Settings
Perform
the
following
procedure
to
initialize
the
calculator,
which
returns
the
calculation
mode
to
COMP
and
returns
all
other
settings,
including
setup
menu
settings,
to
their
initial
defaults.
(swer) (9) (CLR) (1) (Setup) E) (Yes)
E-6