5. On the receiving calculator, press w(RECV) to
set up the calculator to receive data.
The calculator is now ready to receive data.
6. On the sending calculator, press q(TRANSMIT) to
set up the calculator to transmit data.
Press q(MAIN) to send data from the Main
Memory.
Press q(SELECT) to select what data to send.
Press q(SELECT) to select specific data to send.
Press w(ALL) to select all data.
Once the data has been selected, press
u(TRANSMIT) to transmit the selected data.
Press
q(Yes) to transmit the data.
To Next Page
Loading...
