20061001
12-1-1
Connecting Two Units
12-1 Connecting Two Units
The following procedure describes how to connect two units with the connecting cable that
comes equipped as a standard accessory.
u To connect two units
1. Check to make sure that the power of both units is off.
2. Connect the two units using the cable.
3. Perform the following steps on both units to specify 3PIN as the cable type.
(1) From the Main Menu, enter the
LINK mode.
(2) Press 4(CABL). This displays the cable type selection screen.
(3) Press 2(3PIN).
Cable
# Models that are supported for this
configuration are shown below.
fx-9860G SD
fx-9860G
20070101
To Next Page
Loading...
