Casio FX-9860G SD - Page 84

20050401
*
1
The {
° ’ ”
} menu operation is available only
when there is a calculation result on the
display.
*
2
The {ENG} and {ENG} menu operations are
available only when there is a calculation
result on the display.
uu
uu
u Angle Units, Coordinate Conversion, Sexagesimal Operations (ANGL)
[OPTN]-[ANGL]
•{°}/{r}/{g} ... {degrees}/{radians}/{grads} for a specific input value
•{° ’ ”} ... {specifies degrees (hours), minutes, seconds when inputting a degrees/minutes/
seconds value}
•{
° ’ ”
} ... {converts decimal value to degrees/minutes/seconds value}*
1
•{Pol(}/{Rec(} ... {rectangular-to-polar}/{polar-to-rectangular} coordinate conversion
•{'DMS} ... {converts decimal value to sexagesimal value}
uu
uu
u Engineering Symbol (ESYM) [OPTN]-[ESYM]
•{m}/{µ}/{n}/{p}/{f} ... {milli (10
–3
)}/{micro (10
–6
)}/{nano (10
–9
)}/{pico (10
–12
)}/
{femto (10
–15
)}
•{k}/{M}/{G}/{T}/{P}/{E} ... {kilo (10
3
)}/{mega (10
6
)}/{giga (10
9
)}/{tera (10
12
)}/{peta (10
15
)}/
{exa (10
18
)}
•{ENG}/{ENG} ... shifts the decimal place of the displayed value three digits to
the {left}/{right} and {decreases}/{increases} the exponent by three.*
2
When you are using engineering notation, the engineering symbol is also changed
accordingly.
2-4-2
Function Calculations
# ENG/ENG switching is disabled for the following
types of calculation results.
- Result of matrix calculation input in the Math
input mode
- Result of list calculation input in the Math input
mode