Operation Guide 5444/5524
E-9
Configuring Home City Settings ..................................................................... E-42
To configure Home City settings .................................................................. E-42
To change the Daylight Saving Time (summer time) setting ......................... E-45
Configuring Current Time and Date Settings Manually ................................ E-48
To change the current time and date settings manually ............................... E-48
Using the World Time Mode ............................................................................ E-53
To enter the World Time Mode ..................................................................... E-53
To view the time in another time zone .......................................................... E-53
To specify standard time or daylight saving time (DST) for a city ................. E-54
To swap your Home Time and World Time Cities ......................................... E-55
Using the Stopwatch ....................................................................................... E-57
To enter the Stopwatch Mode ...................................................................... E-57
To perform an elapsed time operation .......................................................... E-58
To pause at a split time ................................................................................. E-58
To measure two finishes ............................................................................... E-58
E-8
Contents
About This Manual .............................................................................................E-2
Things to check before using the watch .......................................................... E-4
Charging the Watch ......................................................................................... E-12
To recover from the sleep state .................................................................... E-20
Radio Controlled Atomic Timekeeping .......................................................... E-21
To get ready for a receive operation ............................................................. E-26
To perform manual receive ........................................................................... E-29
To check the latest signal reception results .................................................. E-33
To turn auto receive on and off ..................................................................... E-34
Mode Reference Guide .................................................................................... E-37
Timekeeping ..................................................................................................... E-41
E-7
The watch is now ready for use.
x For details about the watch’s radio controlled timekeeping feature, see “Radio
Controlled Atomic Timekeeping” (page E-21).
E-6
2. Check the Home City and the daylight saving time (DST) setting.
Use the procedure under “To configure Home City settings” (page E-42) to configure
your Home City and daylight saving time settings.
Important!
x Proper time calibration signal reception and World Time Mode data depend on
correct Home City, time, and date settings in the Timekeeping Mode. Make sure
you configure these settings correctly.
3. Set the current time.
x To set the time using a time calibration signal
See “To get ready for a receive operation” (page E-26).
x To set the time manually
See “Configuring Current Time and Date Settings Manually” (page E-48).
E-5
Go to step 2.
The watch is charged.
For details about charging, see “Charging the Watch” (page E-12).
Power is low. Charge the watch by placing it in a location where it is exposed to
light. For details, see “Charging the Watch” (page E-12).
NEXT
E-4
Things to check before using the watch
1. Check the battery power level.
Is H or M indicated as the battery power indicator (page E-15)?
Battery power
indicator
YES
NO
E-3
x Note that the product illustrations in this manual are intended for reference only,
and so the actual product may appear somewhat different than depicted by an
illustration.
E-2
About This Manual
x The operational procedures for Modules 5444 and 5524 are identical. All of the
illustrations in this manual show Module 5444.
x Depending on the model of your watch, display text appears either as dark figures
on a light background, or light figures on a dark background. All examples in this
manual are shown using dark figures on a light background.
x Button operations are indicated using the letters shown in the illustration.
Module 5444 Module 5524
E-1
ENGLISH
Congratulations upon your selection of this CASIO watch.
To ensure that this watch provides you with the years of service for which it is
designed, carefully read and follow the instructions in this manual, especially the
information under “Operating Precautions” and “User Maintenance”.
Be sure to keep all user documentation handy for future reference.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any
damage or loss suffered by you or any third party arising through the use of your
watch or its malfunction.
MA1703-EA
© 2015 CASIO COMPUTER CO., LTD.
To Next Page
Need help?
General