– 2 –
3. Press the key (Local 1, Local 2) to which you want
to assign it.*
1
4. Input the conversion rate (1.95583) and then press SET.
*
1
For rates of 1 or greater, you can input up to six digits.
For rates less than 1 you can input up to 8 digits,
including 0 for the integer digit and leading zeros
(though only six significant digits, counted from the left
and starting with the first non-zero digit, can be
specified).
Examples: 0.123456 0.0123456 0.0012345
•You can check the rate currently assigned to a Local
key (Local 1, Local 2) by pressing AC and then the
key whose settings you want to check. The setting data
appears on the display, but is not printed.
• The following are the factory default rate settings.
Local 1 RATE = 1.95583
Local 2 RATE = 6.55957
Tax Calculations
kSetting a Tax Rate
Example:
Tax rate = 5%
Operation Printout Display
• If you make a mistake while inputting a rate, press C
and then set the correct rate.
•You can check the currently set rate at any time by
pressing AC and then TAX+.
Local 1 1.95583
SET
#1
--------
1
•
95583
1.95583
L1
“PRT”
0.
AC
0
•
C
SET
#
----------------
TAX+5 SET
#
--------------
5
•
T
(about 3 seconds)
0.
SET
5.
TAX %
T&E_HR8TEC_EU15_P01-_0214.p65 06.2.14, 8:38 PM2