E-20
Remove the ink ribbon cassette and check to
make sure the ink ribbon is not broken. Next,
take up any slack in the ink ribbon and then
reload the tape cartridge.
Important!
• Before loading an ink ribbon cassette into
the label printer, always make sure you take
up any slack in the ink ribbon first.
• If the ink ribbon is broken, you must change
to another ink ribbon cassette.
Cannot cut tape.
Possible Cause Action
Tape cutter blade is dull. Take the label printer to the dealer from whom
you purchased it to have the tape cutter blade
replaced.
Printed text is cut off by tape cut operation.
Possible Causes Action
Be sure to press the FEED key before perform-
ing the tape cut operation.
Important!
When the printer is set up for manual tape feed,
the tape is not fed automatically after printing
is complete.
Replace the tape cartridge with a new one.
Ink ribbon cassette loaded
while the ink ribbon is
slack.
Ink ribbon is being fed from the tape outlet along with the tape.
Possible Cause Action
The printer is set up for
manual tape feed.
Out of tape
Label will not adhere to a surface.
Possible Causes Action
Peel the backing paper from the back of the
tape to expose the adhesive.
Labels do not adhere well to surfaces that are
rough, wet, oily, or dirty.
The backing paper is still
on the back of the tape.
Surface is unsuitable for
affixing a tape.
••
••
•
Tape Cutting
••
••
•
Using Labels
To Next Page
Loading...
Need help?
General
