Casio QG-100 - Page 24

— 22 —
• Tape Cutting
Tape does not cut.
Possible Cause Recommended Action
Tape cutter is worn. Consult with your original dealer.
• Label Adhesion
Label does not stick.
Possible Cause Recommended Action
Backing paper is not removed. Remove the backing paper from the label to ex-
pose its adhesive.
Attempt to stick label onto improper object or Labels will not stick to surfaces that are rough,
surface. wet, oily, or dirty.
• Communications
Cannot transfer data.
Possible Cause Recommended Action
Improper cable connections. 1.Turn off digital camera and QG-100 power in
the sequence under *.
2.Press in SB-62 cable plugs as far as they will
go.
3.Turn on digital camera and QG-100 power in
the sequence under *.
• Data Communications
Digital camera error display, no response from QG-100 keys, cannot display digital camera images.
Possible Cause Recommended Action
Improper cable connections. 1.Turn off QG-100 power.
2.Turn off digital camera power.
3.Turn on digital camera and QG-100 power in
the sequence under *.
• During Operation
Image disappears from digital camera monitor screen.
Possible Cause Recommended Action
Dead digital camera batteries. Turn off QG-100 power and then replace digital
camera batteries.
If you continue to have problems after performing the recommended actions described above, consult
with your original dealer.
* REMARK
Refer to 23 ~24 pages on and .
3
5
3
3
5