— 24 —
Turn off power.
1 Turn off the QG-100.
2 Wait until the monitor screen of the digital camera changes from blue to a recorded image.
3 Turn off the digital camera.
4 Disconnect the SB-62 cable from QG-100 and the digital camera.
Important!
The digital camera power may not turn off when you operate its POWER switch if the camera is not
connected correctly to the QG-100 or if you perform an improper operation while they are connected.
If this happens, use one of the following procedures to correct the problem.
• When operating under battery power
1. Remove the batteries from the digital camera.
2. Reload the battries back into the digital camera.
• When operating under AC adaptor power
1. Unplug the AC adaptor from the digital camera.
2. Plug the AC adaptor back into the digital camera.
5
To Next Page
Loading...
