— 9 —
2. Press 4 to select DATA COMM.
3. Press 1 to select SEND.
4. Press 3 to select ALL DATA.
5. Press SET to start the send operation or ESC to abort the operation without sending anything.
• Data is send in the sequence: Telephone Directory, Memo Mode, Reminder Mode, Schedule
Keeper, Calendar.
• To abort the send operation at any time, press ESC.
• If an error occurs during the send operation, the message “TRANSMIT ERROR!” appears on
the display. Press ESC to clear the error message.
6. After the send operation is complete, the display returns to the initial screen of the mode you
were in when you started this procedure.
1 ONE ITEM
2 MODE DATA
3 ALL DATA
- SEND -
SEND ALL DATA?
SET/ESC
4
1
3
1 SEND
2 RECEIVE
3 SET UP
DATA
SENDING
TO STOP
PRESS (ESC)
CAPS
CAPS
CAPS
CAPS
SET or ESC
To Next Page
Loading...
Need help?
General
