Example
For a 4 terminal system you would program the following in the
In-Line connection table
Record 1-91 Master Terminal = 1100
Record 2-91 1
st
Slave Terminal =1200
Record 3-91 2
nd
Slave Terminal =1200
Record 4-91 3
rd
Slave Terminal =1200
After programming these records make sure you flag Mac the
Master terminal.
Sending the In-line connection table across the network
Follow the procedure below to send the In-line connection table
across the network
Command code = 091
Your network is now configured to allow shared check tracking and
floating clerk interrupt.
Please read the next three chapters to set up the flags to allow the
use of Floating check, clerk and shared printing.
28
To Next Page
Loading...
