Need help?Do you have a question about the Cassese CS1 CART and is the answer not in the manual?
General| Operation | Pneumatic |
|---|---|
| V-Nail Sizes | 5, 7, 10, 12, 15mm |
| V-Nail Size Range | 5-15mm |
| Category | Underpinner |
| Type | Pneumatic Underpinner |
| Usage | Framing, Joinery |
| Power Source | Pneumatic |
Detailed steps for securing mouldings and performing the frame joining operation.
Critical safety warnings and personal protective equipment advice before maintenance.
Instructions on how to safely remove the wedge distributor block for cleaning or repair.
Steps for cleaning and lubricating the wedge distributor block to prevent issues.
Procedure for safely removing the wedge driver blade from the machine.
Guide for inserting and securing a new wedge driver blade.
Troubleshooting steps for a jammed wedge distributor block and its components.
To Next Page
