CASTLE Mamba XLX2 - Mamba XLX2 Getting Started Guide; Mamba XLX2 ESC and Motor Installation; Mamba XLX2 Throttle Calibration

RECEIVER CONNECTION
RX Wire Plug the RX wire into the throttle (#) chnnel on your receiver.
AUX Wire
The AUX wire llows you to djust  setting “on-the-fly” using
n uxiliry chnnel on your receiver. The AUX wire function is
disbled by defult nd is progrmmble vi Cstle Link. Plug
this wire into the uxiliry (#/#) chnnel on your receiver.
You UST connect the AUX wire to n open chnnel on your
receiver even if you re not using the Auxiliry function.
TRANSMITTER PROGRAMMING REFERENCE
AUDIBLE ALERT REFERENCE
• •
Strt Fil
• –
Low Voltge Cutoff
– •
Over-Current
• • •
Sensors Lost
• • –
Rdio Glitch
• – •
Over-Temperture
• – –
Excessive Lod
– • •
AUX ire Rdio Glitch
– • –
BEC Over-Temperture
• • • •
Dt Log Full rning
– – •
otor Over-Temperture
1.Brake/Reverse Type 3. Brake Amount 5. Motor Type
• ith Reverse* • % • Brushless*
• ithout Reverse • %* • Brushed Reversing
• Crwler Reverse • %
• % 6. Motor Direction
2.Voltage Cutoff • orml*
• Auto-Lipo* 4. Drag Brake • Reverse
• one • Disbled*
• %
• %
• %
• Crwler Full On *Defult Setting
DRIVER’S ED GUIDE
For more detiled informtion regrding Getting Strted,
Throttle Clibrtion, using Cstle Link, or Trnsmitter
Progrmming, plese red the Driver’s Ed Guide by visiting:
www.cstlecretions.com/mbXLX2DEG
Or scn this QR code with your smart device to open the link.
Postive Battery Wire
Fan Connector Negative Battery Wire
Motor Sensor Wire
Waterproof Switch
AUX Wire
RX Wire
Motor A
Motor B
Motor C
Status
LEDs
GETTING STARTED
. Solder  high qulity bttery connector to the ESC (see Driver’s Ed Guide
“Connectors nd Power iring” ).
. ount the ESC nd motor into the vehicle.
. Connect motor to the ESC (see Driver’s Ed Guide, “otor iring” ).
. Plug in the RX wire into throttle (#) nd AUX wire into uxillry (#/#).
5. Clibrte your ESC to your rdio. (See below).
YOU ARE NOW READY TO GO!
THROTTLE CALIBRATION
1. Rdio on, bttery plugged in, ESC o.
2. Hold full throttle, turn ESC on (green LED).
3. hen red LED flshes, go to full reverse.
4. hen yellow LED flshes, go to neutrl.
5. Armed nd redy!