Need help?Do you have a question about the CASTLE EP and is the answer not in the manual?
General| Brand | CASTLE |
|---|---|
| Model | EP |
| Category | Controller |
| Language | English |
Details on using dip-units (CONF1, CONF2) for basic controller setup and parameter configuration.
Information on DC voltage requirements, current consumption, and PSU specifications for controller operation.
Overview of connecting up to four readers using Wiegand-26, Wiegand-34, or Touch memory interfaces.
Instructions for establishing Ethernet communication and performing initial controller setup.
Overview of how door locks are managed by the controller's four relays (K1-K4).
Using controller relays (K1-K4) for direct control of gate motors, with intermediate relay requirement.
Steps the controller performs upon receiving power, including configuration verification and initialization.
Steps to diagnose issues with voltage supply, PWR indicator, and controller start-up beeps.
Diagnosing lock connection issues: incorrect connections, sensor states, or blown PSU fuses.
Resolving turnstile passage registration errors and incorrect direction detection.
Diagnosing barrier issues like remaining open or erratic movement, checking sensors and overcurrent governors.
To Next Page
