CASTLE EP - Appendix 2. the Controller LED Indication

© AGRGS 2016 | Data subject to change without notice
67385867493098462 | en, eu, V5, 07. Oct 2016, page 167
14. Appendix 2. The controller LED indication
When starting, the controller provides the following indication by using the built-in LEDs.
LED name
Description
PWR
TX
RX
ON
X
X
After power on, upon successful startup of the
controller. Power type mains.
Blinking slowly
X
X
After power on, upon successful startup of the
controller. Power type battery.
Flashing
Flashing
OFF
Boot-up failure: RS485 address is not set on
CONF2 dip-unit.
Flashing
OFF
Flashing
Boot-up failure: incorrect configuration. Check
settings of CONF1 dip-unit.
Flashing
OFF
OFF
Hardware failure. The controller is defective
and is to be replaced.
Table 131. The controller LED indication
When in normal controller operation, a periodic flashing or permanent glow of TX and RX LEDs
occurs, indicating the transmission and the reception of data, respectively.