© AGRGS 2016 | Data subject to change without notice
67385867493098462 | en, eu, V5, 07. Oct 2016, page 15
5. Controller functions in Castle ACS
The Castle controller is designed for operating in the networked Castle ACS managing connected
actuators. Controllers are connected to the server through Ethernet or RS485 link.
Controller operating parameters as part of Castle ACS
Number of independently
stored keys
Number of independently
stored events
Number of independently
stored access modes
(time zones)
Doors equipped with electromagnetic, electromechanical locks or
latches. Door location up to 50 meters from the controller.
Turnstiles. Pulse and potential control supported, as well as three
modes of passage sensor processing logic.
The electromechanical gate, in any configuration.
Barriers or gates single- or double-winged, sliding or hinged
equipped with vehicle presence sensors.
The controller can work without connecting actuators for time
tracking.
Repeated passage
prevention (Anti-pass-
back) and zone control
If you have a connection to the server global Anti-pass-back with
adjustable time control**.
Zone control and staff location monitoring.
Autonomous controller
status indication
Audible indication of controller functions and its configuration errors
Power indication (mains, battery, power supply voltage is out of the
defined range)
Indication of data exchange over Ethernet and RS485 networks
(receiving, transmitting).
Firmware updates
availability
The firmware can be updated via a link from any client computer or a
server connected to the Castle system.
*Note: The distribution of autonomous memory between the keys, modes and custom events can
be customized. The figures given in the table correspond to one of the memory allocation variants.
To Next Page
Loading...
Need help?
General
